KIM-1 Keypad by HackUp on Thingiverse: https://www.thingiverse.com/thing:5596116

Summary:
This is a keypad case that I made for the KIM-1 replica created by user ralf02 on forum64.de.Warning: Still work in progress and subject to change!In addition to the printable components you'll need the following:2 keypads with 16 keys each as shown (actually, you just need 1 1/2)1 keypad PCB (not yet released)1 SPDT slide switch, 2.54mm pitch1 female pin header connector, 15 pins, preferably low profile1 male pin header, 15 pins to match the female one6 self tapping screws, 2x6mmlabels printed white on black for the keys E, F, AD, DA, PC, +, GO, ST, RSdouble sided adhesive tape to glue the clips to the motherboardThe printable feet included here are not for the keypad but for the KIM-1 motherboard itself. You'll need M3 nuts and short screws for these.